Sur-Ron Ultra Bee Rear Tail Light

Rear Tail Light for the Ultra Bee

This replacement rear lamp is designed for the Sur-Ron Ultra Bee tail-light position. It restores the rear lighting assembly when the original lamp is damaged or requires replacement.

Match the Original Light and Wiring

Compare the product images with the light currently fitted to the motorcycle. Check the housing shape, lens, connector keying, pin layout, wire routing, mounting points, and rear bracket arrangement. Ultra Bee lighting configurations can differ, so the original connector and harness layout should be the final match before ordering. Inspect the surrounding wiring and bracket for damage that could affect the replacement light.

Installation and Function Test

Switch the motorcycle off and disconnect or isolate power according to the Ultra Bee service procedure. Route the wiring away from the tire, suspension, sharp edges, and hot or moving parts. Do not pull on the wires when connecting the lamp, and make sure the connector is fully seated and protected from contamination. After installation, reconnect power and test every rear-light function provided by the motorcycle. Confirm that the lamp remains secure and visible through normal suspension movement. Use a qualified technician if the connector, wiring, or lighting function does not match the original setup.