- Type: Ebike Brushless Motor controller 36/48V 17A controller Squarewave
- Brand: KT
- Color: Silver
- Dimension :94*62*35mm
- Mosfet : 6 Mosfets
- Maximum current: 17±1A
- Rated current: 8A
- Rated voltage: DC36V/48V
- Speed set: 1-4.2V
- Brake input: Low-Level
- Low voltage protection: DC30/40±0.5V
- Cable length : all about 10-13cm
- Weight: 200g
FUNCTION & PLUG (all bullet)

motor (9pin waterproof plug ) power (red-black plug)
1T4 cable plug(8pin waterproof plug-Throttle-Display-Ebrake)
PAS (Yellow-3pin waterproof plug)
Notice:
1. KT controller is just only compatible with the KT display(same communication protocol). Please make sure that your system is the KT system. The waterproof connector is special that I can’t promise you it can be 100% compatible(because of the line sequence). But most can use it if you check carefully. Please check your motor cable if it is Juliet or Higo 9pin waterproof plug(there are some letters on the connector ).Juliet is better. But for 250W 350W. Higo is also OK.
2. If your ebrake throttle display and PAS light are all waterproof connectors. Please make sure the brand of your cable. Ours is Juliet. YLS is also could be compatible. But HIGO can/’t be compatible. Please check before ordering it.
3. Please contact us if you have further questions.
Reviews
There are no reviews yet.